Lathe Diameter/Radius offset report issue

[nickshl]

When G7/G8 is send, X DRO changes from Radius/Diameter to some "junk" value, then it changed to correct Radius/Diameter value.
I suspect it happens because WCO does not reported with same report as Radius/Diameter mode:

<Idle|MPos:4.756,0.000,0.000|Bf:100,1024|FS:0,0|WCO:7.800,0.003,0.000>
G7
ok
<Idle|MPos:9.512,0.000,0.000|Bf:100,1024|FS:0,0|D:1>
<Idle|MPos:9.512,0.000,0.000|Bf:100,1024|FS:0,0>
<Idle|MPos:9.512,0.000,0.000|Bf:100,1024|FS:0,0|WCO:15.600,0.003,0.000>

So, between report contains D:1 and last line, old offset is used to calculate X axis position on sender side. Not a terrible bug, but small annoyance. I wish correct WCO can be reported same line as mode, something like that:

<Idle|MPos:4.756,0.000,0.000|Bf:100,1024|FS:0,0|WCO:7.800,0.003,0.000>
G7
ok
<Idle|MPos:9.512,0.000,0.000|Bf:100,1024|FS:0,0|D:1|WCO:7.800,0.003,0.000>

[nickshl]

Works! Thanks.