Rolling restarts and allocation disabling

[markwalkom]

Here we state to use "cluster.routing.allocation.enable" : "none" before restarting nodes.

With the inclusion of index.unassigned.node_left.delayed_timeout in later versions, would it make sense to update our recommended practises to temporarily increase this setting, instead of entirely disabling allocation?

This was raised on this forum issue.

[cheruvian]

Would also be useful to list (in the same area) the exception or response returned when a request to index to a primary shard for that host is attempted.

[clintongormley]

Yes, I think we should probably change this advice. In fact, it's not even a requirement to increase this timeout. If the shard starts reallocating and then a node joins with the shard intact, the reallocation should be cancelled. (not sure what happens with unsync'ed shards).

@ywelsch what do you think?

[ywelsch]

@clintongormley The cancelling only works for synced shards. If there has been write activity on the primary while the node was restarted (or 5 minutes prior to the restart with no explicit synced flush), the existing replica allocation is not cancelled. There is certainly room for future improvements in this area.

If there are writes to be expected on the indices while the node is restarted and it is likely that the node will miss the default delayed timeout, increasing the timeout is a solution. The risk with temporarily increasing the value of node_left.delayed_timeout though is to make sure that the setting is properly reset on all indices (it's an index-level setting) once the node has come back. An alternative would be to temporarily deactivate allocation of replicas (cluster.routing.allocation.enable = primaries) which is a cluster-level setting. Also note that disabling shard rebalancing (cluster.routing.rebalance.enable) might still be useful, which is a different setting than the one recommended by the current documentation (cluster.routing.allocation.enable). By only disabling rebalance, new indices can still be created (and even go to green) but existing active shards will not be moved around (except for situations where node goes above high disk watermark or filter allocation rules changed in hot/warm setup).

[jmcarp]

Am I understanding correctly that the current best practice for rolling restarts is to fiddle with delay allocation instead of setting cluster.routing.allocation.enable?

cc @cnelson @LinuxBozo

[tomsommer]

The documentation still hasn't been changed on this, and no agreement has been found.

To me, it sounds like index.unassigned.node_left.delayed_timeout as a general best-practice should be raised to a enough-time-to-restart-a-server value.

Is the suggestion per #19739 (comment) to set cluster.routing.allocation.enable = primaries and raise index.unassigned.node_left.delayed_timeout when doing rolling updates?

[elasticmachine]

Pinging @elastic/es-distributed