Merge tag 'gpmc-omap-fixes-for-v4.7' of https://github.com/rogerq/linux into fixes

OMAP-GPMC: Fixes for for v4.7-rc cycle:

- Fix omap gpmc EXTRADELAY timing. The DT provided timings
were wrongly used causing devices requiring extra delay timing
to fail.

* tag 'gpmc-omap-fixes-for-v4.7' of https://github.com/rogerq/linux:
  memory: omap-gpmc: Fix omap gpmc EXTRADELAY timing
  + Linux 4.7-rc3

Signed-off-by: Olof Johansson <[email protected]>

Author: olofj

Documentation/devicetree/bindings/hwmon/ina2xx.txt

@@ -7,6 +7,7 @@ Required properties:
 	- "ti,ina220" for ina220
 	- "ti,ina226" for ina226
 	- "ti,ina230" for ina230
+	- "ti,ina231" for ina231
 - reg: I2C address
 
 Optional properties:

Documentation/devicetree/bindings/i2c/i2c-arb-gpio-challenge.txt

@@ -44,8 +44,8 @@ Required properties:
 - our-claim-gpio: The GPIO that we use to claim the bus.
 - their-claim-gpios: The GPIOs that the other sides use to claim the bus.
   Note that some implementations may only support a single other master.
-- Standard I2C mux properties. See mux.txt in this directory.
-- Single I2C child bus node at reg 0. See mux.txt in this directory.
+- Standard I2C mux properties. See i2c-mux.txt in this directory.
+- Single I2C child bus node at reg 0. See i2c-mux.txt in this directory.
 
 Optional properties:
 - slew-delay-us: microseconds to wait for a GPIO to go high. Default is 10 us.

Documentation/devicetree/bindings/i2c/i2c-demux-pinctrl.txt

@@ -27,7 +27,8 @@ Required properties:
 - i2c-bus-name: The name of this bus. Also needed as pinctrl-name for the I2C
 		parents.
 
-Furthermore, I2C mux properties and child nodes. See mux.txt in this directory.
+Furthermore, I2C mux properties and child nodes. See i2c-mux.txt in this
+directory.
 
 Example:
 

Documentation/devicetree/bindings/i2c/i2c-mux-gpio.txt

@@ -22,8 +22,8 @@ Required properties:
 - i2c-parent: The phandle of the I2C bus that this multiplexer's master-side
   port is connected to.
 - mux-gpios: list of gpios used to control the muxer
-* Standard I2C mux properties. See mux.txt in this directory.
-* I2C child bus nodes. See mux.txt in this directory.
+* Standard I2C mux properties. See i2c-mux.txt in this directory.
+* I2C child bus nodes. See i2c-mux.txt in this directory.
 
 Optional properties:
 - idle-state: value to set the muxer to when idle. When no value is
@@ -33,7 +33,7 @@ For each i2c child node, an I2C child bus will be created. They will
 be numbered based on their order in the device tree.
 
 Whenever an access is made to a device on a child bus, the value set
-in the revelant node's reg property will be output using the list of
+in the relevant node's reg property will be output using the list of
 GPIOs, the first in the list holding the least-significant value.
 
 If an idle state is defined, using the idle-state (optional) property,

Documentation/devicetree/bindings/i2c/i2c-mux-pinctrl.txt

@@ -28,9 +28,9 @@ Also required are:
 * Standard pinctrl properties that specify the pin mux state for each child
   bus. See ../pinctrl/pinctrl-bindings.txt.
 
-* Standard I2C mux properties. See mux.txt in this directory.
+* Standard I2C mux properties. See i2c-mux.txt in this directory.
 
-* I2C child bus nodes. See mux.txt in this directory.
+* I2C child bus nodes. See i2c-mux.txt in this directory.
 
 For each named state defined in the pinctrl-names property, an I2C child bus
 will be created. I2C child bus numbers are assigned based on the index into

Documentation/devicetree/bindings/i2c/i2c-mux-reg.txt

@@ -7,8 +7,8 @@ Required properties:
 - compatible: i2c-mux-reg
 - i2c-parent: The phandle of the I2C bus that this multiplexer's master-side
   port is connected to.
-* Standard I2C mux properties. See mux.txt in this directory.
-* I2C child bus nodes. See mux.txt in this directory.
+* Standard I2C mux properties. See i2c-mux.txt in this directory.
+* I2C child bus nodes. See i2c-mux.txt in this directory.
 
 Optional properties:
 - reg: this pair of <offset size> specifies the register to control the mux.
@@ -24,7 +24,7 @@ Optional properties:
   given, it defaults to the last value used.
 
 Whenever an access is made to a device on a child bus, the value set
-in the revelant node's reg property will be output to the register.
+in the relevant node's reg property will be output to the register.
 
 If an idle state is defined, using the idle-state (optional) property,
 whenever an access is not being made to a device on a child bus, the

Documentation/devicetree/bindings/net/marvell-bt-sd8xxx.txt

@@ -13,10 +13,10 @@ Optional properties:
 		      initialization. This is an array of 28 values(u8).
 
   - marvell,wakeup-pin: It represents wakeup pin number of the bluetooth chip.
-		        firmware will use the pin to wakeup host system.
+		        firmware will use the pin to wakeup host system (u16).
   - marvell,wakeup-gap-ms: wakeup gap represents wakeup latency of the host
 		      platform. The value will be configured to firmware. This
-		      is needed to work chip's sleep feature as expected.
+		      is needed to work chip's sleep feature as expected (u16).
   - interrupt-parent: phandle of the parent interrupt controller
   - interrupts : interrupt pin number to the cpu. Driver will request an irq based
 		 on this interrupt number. During system suspend, the irq will be
@@ -50,7 +50,7 @@ calibration data is also available in below example.
 			0x37 0x01 0x1c 0x00 0xff 0xff 0xff 0xff 0x01 0x7f 0x04 0x02
 			0x00 0x00 0xba 0xce 0xc0 0xc6 0x2d 0x00 0x00 0x00 0x00 0x00
 			0x00 0x00 0xf0 0x00>;
-		marvell,wakeup-pin = <0x0d>;
-		marvell,wakeup-gap-ms = <0x64>;
+		marvell,wakeup-pin = /bits/ 16 <0x0d>;
+		marvell,wakeup-gap-ms = /bits/ 16 <0x64>;
 	};
 };

Documentation/devicetree/bindings/vendor-prefixes.txt

@@ -255,6 +255,7 @@ synology	Synology, Inc.
 SUNW	Sun Microsystems, Inc
 tbs	TBS Technologies
 tcl	Toby Churchill Ltd.
+technexion	TechNexion
 technologic	Technologic Systems
 thine	THine Electronics, Inc.
 ti	Texas Instruments
@@ -269,6 +270,7 @@ tronsmart	Tronsmart
 truly	Truly Semiconductors Limited
 tyan	Tyan Computer Corporation
 upisemi	uPI Semiconductor Corp.
+uniwest	United Western Technologies Corp (UniWest)
 urt	United Radiant Technology Corporation
 usi	Universal Scientific Industrial Co., Ltd.
 v3	V3 Semiconductor

MAINTAINERS

@@ -3087,6 +3087,7 @@ M:	Stephen Boyd <[email protected]>
 L:	[email protected]
 T:	git git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux.git
 S:	Maintained
+F:	Documentation/devicetree/bindings/clock/
 F:	drivers/clk/
 X:	drivers/clk/clkdev.c
 F:	include/linux/clk-pr*
@@ -8009,6 +8010,7 @@ Q:	http://patchwork.kernel.org/project/linux-wireless/list/
 T:	git git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers.git
 T:	git git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers-next.git
 S:	Maintained
+F:	Documentation/devicetree/bindings/net/wireless/
 F:	drivers/net/wireless/
 
 NETXEN (1/10) GbE SUPPORT
@@ -8406,23 +8408,20 @@ F:	drivers/i2c/busses/i2c-ocores.c
 OPEN FIRMWARE AND FLATTENED DEVICE TREE
 M:	Rob Herring <[email protected]>
 M:	Frank Rowand <[email protected]>
-M:	Grant Likely <[email protected]>
 L:	[email protected]
 W:	http://www.devicetree.org/
-T:	git git://git.kernel.org/pub/scm/linux/kernel/git/glikely/linux.git
+T:	git git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux.git
 S:	Maintained
 F:	drivers/of/
 F:	include/linux/of*.h
 F:	scripts/dtc/
 
 OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS
 M:	Rob Herring <[email protected]>
-M:	Pawel Moll <[email protected]>
 M:	Mark Rutland <[email protected]>
-M:	Ian Campbell <[email protected]>
-M:	Kumar Gala <[email protected]>
 L:	[email protected]
 T:	git git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux.git
+Q:	http://patchwork.ozlabs.org/project/devicetree-bindings/list/
 S:	Maintained
 F:	Documentation/devicetree/
 F:	arch/*/boot/dts/

Makefile

@@ -1,7 +1,7 @@
 VERSION = 4
 PATCHLEVEL = 7
 SUBLEVEL = 0
-EXTRAVERSION = -rc2
+EXTRAVERSION = -rc3
 NAME = Psychotic Stoned Sheep
 
 # *DOCUMENTATION*