clk: qcom: gcc-qcs404: fix initial rate of GPLL3

The comment before the config of the GPLL3 PLL says that the
PLL should run at 930 MHz. In contrary to this, calculating
the frequency from the current configuration values by using
19.2 MHz as input frequency defined in 'qcs404.dtsi', it gives
921.6 MHz:

  $ xo=19200000; l=48; alpha=0x0; alpha_hi=0x0
  $ echo "$xo * ($((l)) + $(((alpha_hi << 32 | alpha) >> 8)) / 2^32)" | bc -l
  921600000.00000000000000000000

Set 'alpha_hi' in the configuration to a value used in downstream
kernels [1][2] in order to get the correct output rate:

  $ xo=19200000; l=48; alpha=0x0; alpha_hi=0x70
  $ echo "$xo * ($((l)) + $(((alpha_hi << 32 | alpha) >> 8)) / 2^32)" | bc -l
  930000000.00000000000000000000

The change is based on static code analysis, compile tested only.

[1] https://git.codelinaro.org/clo/la/kernel/msm-5.4/-/blob/kernel.lnx.5.4.r56-rel/drivers/clk/qcom/gcc-qcs404.c?ref_type=heads#L335
[2} https://git.codelinaro.org/clo/la/kernel/msm-5.15/-/blob/kernel.lnx.5.15.r49-rel/drivers/clk/qcom/gcc-qcs404.c?ref_type=heads#L127

Cc: [email protected]
Fixes: 652f181 ("clk: qcom: gcc: Add global clock controller driver for QCS404")
Signed-off-by: Gabor Juhos <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Bjorn Andersson <[email protected]>

Author: juhosg

drivers/clk/qcom/gcc-qcs404.c

@@ -131,6 +131,7 @@ static struct clk_alpha_pll gpll1_out_main = {
 /* 930MHz configuration */
 static const struct alpha_pll_config gpll3_config = {
 	.l = 48,
+	.alpha_hi = 0x70,
 	.alpha = 0x0,
 	.alpha_en_mask = BIT(24),
 	.post_div_mask = 0xf << 8,