i2c: rtl9300: Add missing count byte for SMBus Block Ops

The expected on-wire format of an SMBus Block Write is

  S Addr Wr [A] Comm [A] Count [A] Data [A] Data [A] ... [A] Data [A] P

Everything starting from the Count byte is provided by the I2C subsystem in
the array data->block. But the driver was skipping the Count byte
(data->block[0]) when sending it to the RTL93xx I2C controller.

Only the actual data could be seen on the wire:

  S Addr Wr [A] Comm [A] Data [A] Data [A] ... [A] Data [A] P

This wire format is not SMBus Block Write compatible but matches the format
of an I2C Block Write. Simply adding the count byte to the buffer for the
I2C controller is enough to fix the transmission.

This also affects read because the I2C controller must receive the count
byte + $count * data bytes.

Fixes: c366be7 ("i2c: Add driver for the RTL9300 I2C controller")
Signed-off-by: Sven Eckelmann <[email protected]>
Cc: <[email protected]> # v6.13+
Reviewed-by: Chris Packham <[email protected]>
Tested-by: Chris Packham <[email protected]>
Signed-off-by: Andi Shyti <[email protected]>
Link: https://lore.kernel.org/r/[email protected]

Author: ecsv

drivers/i2c/busses/i2c-rtl9300.c

@@ -285,15 +285,15 @@ static int rtl9300_i2c_smbus_xfer(struct i2c_adapter *adap, u16 addr, unsigned s
 			ret = -EINVAL;
 			goto out_unlock;
 		}
-		ret = rtl9300_i2c_config_xfer(i2c, chan, addr, data->block[0]);
+		ret = rtl9300_i2c_config_xfer(i2c, chan, addr, data->block[0] + 1);
 		if (ret)
 			goto out_unlock;
 		if (read_write == I2C_SMBUS_WRITE) {
-			ret = rtl9300_i2c_write(i2c, &data->block[1], data->block[0]);
+			ret = rtl9300_i2c_write(i2c, &data->block[0], data->block[0] + 1);
 			if (ret)
 				goto out_unlock;
 		}
-		len = data->block[0];
+		len = data->block[0] + 1;
 		break;
 
 	default: