gianfar: Restore link state settings after MAC reset

There are some MAC registers that need to be kept in sync
with the link state parameters, see adjust_link().
However, after a MAC soft reset default values for
these registers are assumed.  In some cases (excepting
if down/ if up for example) adjust_link() does not see
that these values were reset to default because the
priv->old* link parameters were left unchanged.
So, reset the priv->old* link params as well during a
MAC reset to let adjust_link() restore the MAC link
settings to the actual link state values.

Fixes following case, for example:
Setting link to 100M, changing MTU (implies MAC reset),
link state remains unchanged to 100M but MAC registers
were reset to default (1G) breaking the connectivity w/
the PHY.  Closing and re-opening the interface would
restore the MAC link parameters to the correct values.

Signed-off-by: Claudiu Manoil <[email protected]>
Signed-off-by: David S. Miller <[email protected]>

Author: claudiu-m

drivers/net/ethernet/freescale/gianfar.c

@@ -2102,6 +2102,11 @@ int startup_gfar(struct net_device *ndev)
 	/* Start Rx/Tx DMA and enable the interrupts */
 	gfar_start(priv);
 
+	/* force link state update after mac reset */
+	priv->oldlink = 0;
+	priv->oldspeed = 0;
+	priv->oldduplex = -1;
+
 	phy_start(priv->phydev);
 
 	enable_napi(priv);